International Scout clips, knobs and trim

3 free models for the Scout II. Only a couple of parts so far. If you have an old International Harvester Scout and a printer, we want to hear from you.

Every model here is someone else's work. Download it from the creator's page, and give them a like while you're there.
Licenses vary. Dashed tags are non-commercial or personal-use only: print them for your truck, don't sell them. A few are files attached to forum posts with no license stated; those link to the thread.
Print in PETG, ASA or nylon. PLA goes soft in a cab in July. Check fitment against your old part before you print ten.

International Scout parts

3 parts

Tail light housing for 6 in ovals
1971-1980 Scout II (built on a 1976), bolts into the stock tail light holes

ASA at 60% infill. Uses 10-32 rivet nuts and a neoprene gasket.

by Brisco Humes CC BY-NC 43 downloads Printables
Shift cover
1977 Scout II

by Ohm & Hammer Workshop CC BY-NC-SA 33 downloads MakerWorld
Front blinker delete plate
IH Scout front end, covers the stock blinker holes after the blinkers are removed

ABS, 100% infill, ironing on top.

by JerradMC90 CC BY-NC 21 downloads Printables

Any make

2 parts

Clips that fit more than one make. Measure before you print.

Grille clip
Isuzu, Toyota, Mazda and Mitsubishi grilles Isuzu 8942180270 · Toyota 90467-13011

by Afrokid CC BY-SA Thingiverse
Push-in rivet clip, 6 to 10 mm
Any make. Measure the hole and the panel

by tom TTU CC BY-NC-SA 1,234 downloads Printables

Questions

Are these International Scout parts free?

Yes. All 3 are free to download from the creator's page. All of them are personal or non-commercial use only, so print them for your own rig and don't sell them. The license is on every row.

How do I find the right clip for my International Scout?

Pull the old clip and compare it with the preview photos and what each part fits.

What filament should I print trim clips in?

PETG, ASA or nylon. PLA goes soft in a hot cab, so save it for a test fit. Print one, check it against the old clip, then print the rest.

Where do the files come from?

2 from Printables and 1 from MakerWorld. LRDT doesn't host the files; every part links to its creator's page.

Can I add a part?

Yes. Send the link with the form at the bottom of this page. We check the fit and the license, then add it with the creator's name on it.

Send us one

Know a part we're missing?

Drew one yourself, or found one that saved your weekend? Send the link. We check the fit and the license, then add it here with the creator's name on it. FJ Cruiser trim clips, JL and Gladiator hardtop clips, 2nd-gen Trooper push clips and Patrol clips are the gaps we'd most like to fill.